Siemens SINUMERIK 840Di sl Operating Manual page 218

5
Parameters operating area
5.3 Tool management
Reactivate
Unload
Relocate
In the
cabinet
Update
filter
Recall "^"
5-218
"Unload"
"Delete" is initiated as a batch command for the selected tools.
Loaded tools are unloaded prior to deletion. You are prompted to
specify the unloading point in a dialog box.
"Unload" is initiated as a batch command for the selected tools. The
tools are not deleted. You are prompted to specify the unloading point
in a dialog box.
"Relocation" is initiated as a batch command for the selected tools. A
dialog box prompts you to enter the destination magazine where the
tools are to be relocated. This magazine is the destination for all tools
in this batch processing operation.
The "In the cabinet" batch command is initiated for the selected tools.
This function is similar to the "Delete" function; in addition, the tool
data are saved in the tool cabinet database. Loaded tools are
unloaded before being saved and deleted. In this case, the unloading
point is queried interactively.
The current filter and its magazine settings are used again and a new
hit list produced. The tool selection for batch processing is canceled
completely.
The current number of hits is discarded and the 1st screen, "Filter
selection", is displayed.
If batch processing has been started and the necessary entries have
been made, the display switches to the 3rd screen, "Batch execution".
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.