Program Editing - Siemens SINUMERIK 840Di sl Operating Manual

4
Machine operating area
4.6 Automatic mode

4.6.7 Program editing

Edit
program
Program Program
or
level + level -
Cycle Start
4-140
Function
As soon as a syntax error in the part program is detected by the
control, program execution is interrupted and the syntax error is
displayed in the alarm line.
You can switch to the program editor and monitor the program
execution in a full-screen display. If an error occurs (Stop state), you
can edit the program in the program editor.
Sequence of operations
"AUTO" mode is selected in the "Machine" operating area.
It is not possible to overtravel the point of interruption. The feedrate
override switch is active.
The program status is "Stopped" or "Reset".
When you press this softkey, the correction editor is displayed, the
softkey bars change and the softkey "Edit" is highlighted.
If an error occurs, the faulty block is highlighted and can be corrected.
Using editor functions "Overwrite", "Highlight block", "Insert block",
"Go To..." and "Find...", you can edit the program in the compensation
block editor.
You can toggle between program levels using these softkeys.
Press "Level -" to view the program in which the faulty routine is
called. You can return to the program to be edited by pressing "Level
+". This is only possible if the NC has a compensation block.
After you have corrected the error, you can continue the program run
by pressing "NC Start".
• NC Stop status:
Only program lines that have not yet been executed can be edited.
• Reset status:
All program lines can be edited.
Note:
You cannot use the "Program editing" function if you are executing a
program from the hard disk.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
4
01/2008
© Siemens AG 2008 All rights reserved.