Siemens SINUMERIK 840Di sl Operating Manual page 323

Hide thumbs Also See for SINUMERIK 840Di sl:
Table of Contents

Advertisement

6
01/2008
Start label
Stop label
Channel
Spindle
Off
Milling
Turning
Milling
Drehen
Copy
Paste
Delete
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Path label from which a program is simulated. If this is not specified,
simulation takes place from program start.
Path label up to which a program is simulated. If this is not specified,
simulation takes place to program end.
(See also "Multi-channel, section by section program simulation".)
Processing channel in the SIMNCK interpreter
Turning: MS main spindle, CS counterspindle, var variable controlled
via NC vocabulary word.
(Milling: currently unused)
Skipping The designated section/program is not simulated in the
current session.
Leads to the manufacturer-specific channel settings (subject to correct
Channel
password).
settings
Constant machine arrangement
Machine arrangement in front or behind turning center.
Leads to the manufacturer-specific spindle settings (subject to correct
Spindle
password).
settings
currently unused
Defines longitudinal offset for main spindle and counterspindle,
longitudinal mirroring on/off, NC keyword definitions for spindle
switchover.
Copy selected line of machining list to clipboard.
Insert the machining list line that was copied/deleted from the
clipboard at the position of the selected line (the selected line is
moved down one row).
Delete the selected line from the machining list
"Program" operating area
6.8
Program simulation
6
6-323

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d slSinumerik 840d

Table of Contents