Siemens SINUMERIK 840Di sl Operating Manual page 175

5
01/2008
Tool wear: Fine offset
Tool
offset
R-
Parameter
Setting
data
Work offset
User
data
Determine
offset
T-No.
+
T-No.
-
D-No.
+
D-No.
-
Delete...
Go to...
Overview
New
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
If you at least have the right entered in MD 9202:
USER_CLASS_TOA_WEAR, you can incrementally change the
values of the tool fine offset. The difference between the old and new
values must not exceed the limit stored in MD 9450:
WRITE_TOA_FINE_LIMIT.
Horizontal softkeys
You can select different data types with the horizontal softkeys:
Selection of "Tool offset" menu
Selection of "R parameters" menu
Selection of "Setting data" menu
Selection of "Work offset" menu
Selection of "User data" menu
Support in determining tool offsets. This softkey is not required if the
tool management function is available.
Vertical softkeys
The vertical softkeys support data input:
Selection of the next tool
Selection of the previous tool
Selection of next highest offset number (cutting edge)
Selection of next lowest offset number (cutting edge)
Deletion of a tool or cutting edge
Find any tool or the active tool
List of all available tools
New cutting edge or a new tool
Parameters operating area
5.2 Tool offset
5
5-175