Siemens SINUMERIK 840Di sl Operating Manual page 300

6
"Program" operating area
6.7 Free contour programming
6-300
The relevant (non-symmetrical) part of the contour is described as
standard:
The finished contour is created through mirroring and repetition:
The lines of symmetry are displayed using a dashed line. The mid
point of the created contour is marked with a cross. The symmetry is
only visible on the end point.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
6
01/2008
© S iemens AG 2008 All rights reserved.