Slave Mode Setting (Master/Slave) - JRC JMA-5912-6 Instruction Manual

7.2.5

Slave Mode Setting (Master/Slave)

Place the system in the Slave
echoes by using radar signals from other radar equipment.
The input value of externally input bearing pulses can be set. The system can set 2048 pulses or 4096
pulses.
[I] Slave Mode Setting (Master/Slave)
Procedures 1. Open the Serviceman Menu.
2. Open the Installation Menu by performing the following menu
3. Select Slave for the item
[II] Setting of Input Bearing Pulse (Input BP Count)
Procedures 1. Open the Serviceman Menu.
2. Open the second page of the Installation Menu by performing the
3. Set the number of pulses for the item
mode when it is to be operated as the sub-display that displays radar
operation.
2. Installation Menu
Master : The system operates as radar equipment while the own antenna is
connected.
Slave : The system operates as a sub-display while the signal cable of other radar
equipment is connected.
following menu operation.
2. Installation Menu
→ 9. Next
menu.
2048 : 2048 pulses per antenna rotation
4096 : 4096 pulses per antenna rotation
2. Master/Slave
1. Input BP Count
7-17
in the menu.
in the