Plotting A Line - JRC JMA-5912-6 Instruction Manual

Plotting a line

Procedures 1
2
3
4
5
6
Press the [MARK] key to select the line mode.
The line pattern to be used is displayed in the line pattern switching (upper right of the
display ② on page 2-19).
Put the cursor on line pattern switching
display ② on page 2-19), and press the [ENT] key.
Line patterns are switched.
Put the cursor on line color switch C
on page 2-19), and press the [ENT] key.
Line colors are switched.
Put the cursor on a location of the display at which you want to start
plotting a line, and press the [ENT] key.
The start point of the specified line will be displayed.
Move the cursor to a location of the display at which you want to
finish plotting the line, and press the [ENT] key.
A line is plotted between the previous point and the end point.
Repeat this procedure so that sequential lines can be plotted.
When you want to finish plotting the line, press the [ENT] key at the
previous point.
Line plotting will be terminated.
To plot another line, repeat procedures 4 to 6.
(upper right of the display ③
3-55
------- (upper right of the