JRC JMA-5912-6 Instruction Manual page 111

Increasing or decreasing a numeric value
Procedures 1 On the numeric value input menu, put the cursor on
then press the [ENT] key to increase or decrease numeric value so as
to change to the desired numeric value.
For example, to change bearing value of 123.0 ° to 123.4 °, put the cursor sequentially
on + located on the software numeric value input menu, and then press the [ENT]
key four times.
* Turning the [MULTI] dial will conduct the same operation.
2 Make sure that the entered value is correct, put the cursor on
and then press the [ENT] key.
The set value is reflected to the operating state.
3 To cancel input, put the cursor on CLR , and then press the [ENT]
key.
The numeric value input menu will close without reflecting the set value to the
operating state.
3.3 Operation Procedures
3-16
+ or - , and
3
ENT ,