JRC JMA-5912-6 Instruction Manual page 273

[IV] Gate Display
The gate displays an area monitoring a target using the Target Tracking function. This radar equipment
allows the gate size to change automatically according to target range and size. User can check the gate
size using the following function.
Procedures 1 Press the [TT MENU] key.
2 Open the TT Test Menu by performing the following menu operation.
3 Press the [4] key.
The gate display mode is switched.
On
Off
4 Display the numeric value of a target according to Section 5.2.3.
The numeric value of the target will be displayed, and the tracked target symbol will
be enclosed in a green gate.
Note: The Target Tracking can display the gate of two targets simultaneously.
9. TT Test Menu
: Gate is displayed
: Gate is not displayed
5-30
5.2 Target Tracking Operation
5