Master/Slave/Demo; Own Outline; Barge Outline; Bearing Marker - JRC JMA-3400 Series Instruction Manual

8.8.1 MASTER/SLAVE/DEMO

Master: Set to this item when connecting to scanner.
Slave: Set to this item when input video signal of external source to display echo without scanner.
Demo: Set to this item when no video signal is input from external source and no scanner is connected.

8.8.2 OWN OUTLINE

Select the own ship outline display on/off.
You can set the outline of the own ship in meters. In order to reduce the distance measurement error due to
radar, please also set the installation position of the scanner.
Select each setting item.

8.8.3 BARGE OUTLINE

Select the own ship outline display on/off.
You can set the outline and position of the barge ship in meters.

8.8.4 BEARING MARKER

Set the bearing marker to display rotated image along the bearing signal.
Select " Rotate Step " and set the unit of angle for rotating the marker.
This function only works in Head Up (H-UP) mode.

8.8.5 OPERATION NUMERIC DISPLAY

Turn on/off the numeric display.
If this function is turned on, numeric information is displayed when following operation performed.
EBL/VRM/Parallel Cursor/Gain/Sea/Rain/Brill/PRF fine tuning
Numeric display is disappeared after the operation.
Chapter 8 DETAIL PERFORMANCE
Press the cross key or turn the
* The same operation can be used to enter
2. Full Width ~ 6.Scanner (side).
SETTINGS
MULTI
control to set the value.
169