Chapter 8: Installation verification
This chapter provides the following information about how to verify the media server installation
and configuration:
Testing the SIPI circuit packs
●
Testing the license file
●
Checking LED status indicators
●
- Media servers
- Uninterruptible power supplies (UPSs)
- Circuit packs
Testing the SIPI circuit pack
The following steps test the clock and packet interface components within the TN8412AP SIPI
circuit pack.
1. In a SAT command line, type test ipserver-interface UUC and press Enter,
where UUC is the cabinet and the carrier in which the circuit pack is located.
2. Verify that the Test Results screen shows PASS in the Results column.
Testing the license file
!
Important:
Wait at least 30 minutes after you install the Communication Manager license
Important:
before you run this test.
1. On a SAT command line, type test license and press Enter.
2. Verify that the Test Results screen shows PASS in the Results column.
Installing and Configuring the Avaya S8400 Media Server
53
February 2007