Platform Recovery Overload - Genie Z-40/23N Service And Repair Manual

Service and Repair Manual
Platform Components
2-4
Platform Overload Recovery
Message (software 1256908A and
later)
If the platform controls LCD screen displays
OVERLOAD RECOVERY, the emergency lowering
system has been used while the platform was
overloaded.
How to Clear the Platform
Overload Recovery Message
Note: This message shall be cleared by a person
trained and qualified on the troubleshooting and
repair of this machine.
Note: Use the following chart to identify the
description of each LCD screen control button used
in this procedure.
1 Turn the key switch to platform control.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down on the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction while holding the steer
rocker switch in the right direction.
26
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer rocker switch.
Result: The display will show FAULTS.
6 Momentarily activate the drive enable toggle
switch in the right direction.
Result: The display will show ACTIVE
FAULTS.
7 Momentarily activate the steer rocker switch in
the right direction until RESET OVERLOAD
MSG is shown on the display.
8 Momentarily activate the drive enable toggle
switch in the right direction.
Result: The display will show ENTER
PASSWORD.
9 Momentarily active the steer rocker switch in
the following order.
Steer right, steer right, steer right, steer left.
Result: A one second audible alarm pulse
verifies the message has been reset.
Result: The alarm does not sound. Repeat this
procedure starting with step 8.
10 Push in the red Emergency Stop button to the
off position.
11 Pull out the red Emergency Stop button to the
on position.
OVERLOAD RECOVERY is not shown on the
display.
Z-40/23N, Z-40/23N RJ
September 2016
Part No. 1268528