Server Name Screen - ZyXEL Communications NAS326 User Manual

9.4 Server Name Screen

Click Control Panel > System > Server Name to open the following screen. Use this screen to configure
your CIFS settings. In this screen you can set your server name and specify if your NAS is a part of a
workgroup.
Note: CIFS cannot be disabled on the NAS.
Figure 119 Control Panel > System > Server Name
The following table describes the labels in these screens.
Table 86 Control Panel > System > Server Name
LABEL
Server Name
Description
Workgroup Name
Prevent NAS From
Being Master
Browser
Apply
Reset
Chapter 9 Control Panel: System
DESCRIPTION
Enter a name to identify your NAS on the network in this field.
You can enter up to 15 alphanumeric characters with minus signs allowed but not as the last
character. The name must begin with an alphabet (a-z) and is NOT case sensitive.
Add text here to describe the NAS if the Server Name field is not enough. Use up to 61
characters. You can use all characters except the following: /\:|[]<>+;,?=*"~.
Type your workgroup name in this field. A workgroup is a group of computers on a network
that can share files. These user accounts are maintained on the NAS.
You can enter up to 15 alphanumeric characters with minus signs allowed but not as the last
character. The name must begin with an alphabet (a-z) and is NOT case sensitive.
Select this option if computers in your workgroup are named with non-English characters
(such as Chinese and Russian). When you perform a search in the workgroup, this option
allows you to locate computers named with non-English characters.
Click this to save your changes.
Click this to restore previously saved settings.
NAS Series User's Guide
149