Software Configuration - Genie TMZ-50/30 Service Manual

Section 4 • Repair Procedures
800-610-4101
ActionRental.com
GROUND CONTROLS
7-3

Software Configuration

The TMZ-50/30 can be adjusted to different
configurations by changing the combination of DIP
switch settings. The DIP switch is located on the
CPU circuit board, found inside the top of the
ground control box. Programming for all
configurations of the Genie TMZ-50/30 is
contained in the EPROM, which is installed onto
the CPU circuit board.
How to Determine
the DIP Switch Configuration
A diagnostic display was
incorporated into the ground
controls after serial number
T5002-24. The following
procedure will not apply to
machines before serial number
T5002-25.
1 Turn the key switch to platform control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
4 - 30
2 Press and hold both the secondary down button
and the turntable rotate counterclockwise
button at the ground controls.
Result: The DIP switch settings will appear in
the diagnostic display.
The display will show each toggle
of the DIP switch in numerical
order from 1 through 16, and
whether the toggle is in the on
position (01) or off position (00).
For example, 0401 shown in the
diagnostic display indicates that
the fourth toggle is in the on
position.
STOP
a
a
b
TMZ-50/30
June 2005
REV B
ENGINE
POWER BATTERY
CHARGE
BATTERY
POWER
BOOM
FUNCTION
EXTEND
ENABLE
OUTRIGGER(S)
AUTOMATIC
LEVELING
RETRACT
OUTRIGGER(S)
52569 A
b
secondary down
turntable rotate counterclockwise
Part No. 65162