Perform Engine Maintenance - Honda Models (If Equipped) - Genie TMZ-50/30 Service Manual

Section 3 • Scheduled Maintenance Procedures
800-610-4101
ActionRental.com
CHECKLIST E PROCEDURES
11 Install the hydraulic tank and install and tighten
the hydraulic tank mounting fasteners. Torque
to specification.
Torque specifications
Hydraulic tank mounting fasteners, dry
Hydraulic tank mounting fasteners, lubricated 45 in-lbs
12 Install the hydraulic filter head onto the machine
and securely tighten the fasteners. Do not over
tighten.
13 Install the hydraulic lines into the filter head and
torque to specification. Refer to Section 2,
Specifications.
14 Connect the battery pack to the machine.
15 Fill the hydraulic tank with hydraulic oil until the
fluid is at the
MAX
overfill. Refer to Section 2, Specifications.
16 Activate the pump to fill the hydraulic system
with oil and bleed the system of air.
Component damage hazard. The
pump can be damaged if operated
without oil. Be careful not to empty
the hydraulic tank while in the
process of filling the hydraulic
system.
17 Repeat steps 15 through 16 until the hydraulic
system and tank are both full. Inspect for leaks.
18 Clean up any oil that may have spilled.
3 - 32
60 in-lbs
6.7 Nm
5.1 Nm
mark on the tank. Do not
E-2
Perform Engine Maintenance -
Honda Models (if equipped)
Engine specifications require that
this procedure be performed every
two years.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information is available in the Honda
GX340 Engine Owner Manual
(Honda part number 31ZH9603).
Honda GX340 Owner's Manual
Genie part number
TMZ-50/30
June 2005
REV B
97361
Part No. 65162