Connector Circuit Board - Genie TMZ-50/30 Service Manual

June 2005
800-610-4101
ActionRental.com
REV A
7-2

Connector Circuit Board

The connector circuit board connects the wire
harness to the CPU circuit board using several
cables.
How to Remove
the Connector Circuit Board
1 Disconnect the battery pack from the machine.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
2 Tag and disconnect the wire harness
connectors from the ground control box.
3 Remove the four lid retaining fasteners from the
ground control box. Open the lid.
4 Tag and disconnect all wiring from the
connector circuit board.
Component damage hazard.
Electrostatic discharge (ESD) can
damage printed circuit board
components. Use a grounded
wrist strap at all times when
handling printed circuit boards.
5 Remove the connector circuit board mounting
fasteners and remove the connector circuit
board.
Part No. 65162 TMZ-50/30
Section 4 • Repair Procedures
GROUND CONTROLS
4 - 29