Table of Contents
Advertisement
2.10.5 IrDA Connector
1 2 3 4 5
IrDA (J6)
The system board is equipped with an IrDA connector for wireless
connectivity between your computer and peripheral devices. The
IRDA (Infr ared Data Association) specification suppor ts data
transfers of 115K baud at a distance of 1 meter.
Connect your IrDA cable to connector J6 on the system board. Set
"UART Mode Select" in the Integrated Peripherals submenu of the
BIOS to the type of IrDA standard supported by your device. You
must have the proper drivers installed in your operating system to
use this connector. Refer to your operating system's manual or
documentation.
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable to the IrDA connector
according to their pin functions.
Hardware Installation
Pin
Function
1
VCC
2
N. C.
3
IRRX
4
Ground
5
IRTX
2
43
Advertisement
Table of Contents
