Table of Contents
Advertisement
Hot Key
When this option is selected, move the cursor to
the "Hot Key Power On" field to select a function
key you would like to use to power-on the system.
The options are from Ctrl-F1 to Ctrl-F12.
Mouse Left
When this option is selected, double-click the left
button of the mouse to power-on the system.
Mouse Right When this option is selected, double-click the right
button of the mouse to power-on the system.
Any Key
Press any key to power-on the system.
Keyboard 98 When this option is selected, press the "wake up"
key of the Windows
power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address for
the onboard serial por t 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows
manually select an I/O address for the onboard serial
port 1 and serial port 2.
Disabled Disables the onboard serial por t 1 and/or serial port 2.
UART Mode Select
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J6) and the COM 2 serial port (J4) at the same time. If you
are using the COM 2 serial por t, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J6 on the system
board.
Award BIOS Setup Utility
system and remove the battery. Wait for a
few seconds and install it back before
powering-on the system.
98 compatible keyboard to
3
you
to
77
Advertisement
Table of Contents
