DFI-ITOX GIC68-B User Manual page 13

Wake-On-Keyboard/Wake-On-Mouse
This function allows you to use the keyboard or PS/2 mouse to
power-on the system. Refer to "Jumper Settings for PS/2 Wake Up"
in chapter 2 and "Power On Function" in the Integrated Peripherals
section in chapter 3 for more information.
Important:
• The power button will not function once a keyboard
password has been set in the "KB Power On Password"
field of the Integrated Peripherals submenu. You must type
the correct password to power-on the system. If you forgot
the password, power-off the system and remove the
battery. Wait for a few seconds and install it back before
powering-on the system.
• The 5VSB power source of your power supply must
support ≥ 720mA.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB
keyboard to wake up a system from the S3 (STR - Suspend To
RAM) state. Refer to "Jumper Settings for USB Wake Up" in chapter
2 and "USB KB Wake-Up From S3" in the Power Management
Setup section in chapter 3 for more information.
Important:
• If you are using the Wake-On-USB Keyboard function for 2
USB ports, the 5VSB power source of your power supply
must support ≥ 1.5A.
• If you are using the Wake-On-USB Keyboard function for 3
or more USB ports, the 5VSB power source of your power
supply must support ≥ 2A.
RTC Timer to Power-on the System
The RTC installed on the system board allows your system to
automatically power-on on the set date and time. Refer to "Resume
By Alarm" in the Power Management Setup section in chapter 3 for
more information.
Introduction
1
13