Ide Disk Drive Connector - DFI-ITOX GIC68-B User Manual

2.10.4 IDE Disk Drive Connector

The system board is equipped with two shrouded PCI IDE headers
that will interface four Enhanced IDE (Integrated Drive Electronics)
disk drives. To prevent improper IDE cable installation, each shrouded
PCI IDE header has a keying mechanism. The 40-pin connector on
the IDE cable can be placed into the header only if pin 1 of the
connector is aligned with pin 1 of the header. You can enable or
disable the onboard primary or secondary IDE controller in the
Integrated Peripherals submenu of the BIOS.
Connecting the IDE Disk Drive Cable
1. If you are connecting two IDE drives, install the 40-pin connector
of the IDE cable into the primary shrouded IDE header (IDE 1 -
J16). If you are adding a third or fourth IDE device, install the
40-pin connector of the other IDE cable into the secondary
shrouded IDE header (IDE 2 - J15).
2. Install the other 40-pin header connector(s) into the device with
the colored edge of the ribbon cable aligned with pin 1 of the
drive edge connector(s).
Hardware Installation
CompactFlash
socket (CN9)
40 39 40
1
2 2
IDE 2 IDE 1
(J15) (J16)
2
39
1
41