Irda Connector - DFI-ITOX LT600-DR User Manual

2
Hardware Installation

IrDA Connector

Connect the cable connector from your IrDA module to the IrDA
connector.
BIOS Setting
Configure the onboard IrDA in the Integrated Peripherals submenu
("Super IO Device" section) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
You may need to install the proper drivers in your operating system
to use the IrDA function. Refer to your operating system's manual or
documentation for more information.
46
5
IRTX
Ground
IRRX
N. C.
VCC 1
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable to the IrDA connector accord-
ing to their pin functions.