Table of Contents
Advertisement
2.10.9 Wake-On-LAN Connector
The Wake-On-LAN function is applicable only when you are using a
LAN add-in card that has the same function. It will allow the
network to remotely power-on a Soft Power Down (Soft-Off) PC.
However, if your system is in the Suspend mode, you can power-on
the system only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the "Wake Up
On LAN_conn" field in the Power Management Setup of the BIOS.
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J19 on the system board. The network will detect Magic
Packet and assert a wakeup signal to power-up the system. Refer to
the add-in card' s manual for details. Note: Your LAN card must
support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥ 720mA.
Pin
Function
1
WOL
2
Ground
3
+5VSB
Hardware Installation
3 2 1
Wake-On-LAN
(J19)
2
47
Advertisement
Table of Contents
