DFI-ITOX GIC68-B User Manual page 76

3
Award BIOS Setup Utility
Watchdog Function
Enabled Enables the Watchdog function.
Disabled Disables the Watchdog function.
Refer to Appendix A for more information.
IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system BIOS
Disabled The IDE HDD uses the standard mode.
Power On Function
This field allows you to use the keyboard or PS/2 mouse to power-
on the system. To use this function, make sure JP1 is set to 2-3 On -
Enabled. Refer to "Jumper Settings for PS/2 Wake Up" in chapter 2
for more information.
Button only
Password
76
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
Default setting. Uses the power button to power
on the system.
Warning:
. .
.
.
.
.
.
.
If JP1 was previously enabled with a pass-
word set in the "KB Power On Password" field,
and now you wish to disable the keyboard
password function, make sure to set this field
to disabled prior to setting JP1 to disabled
(1-2 On). You will not be able to boot up the
system if you fail to do so.
When this option is selected, move the cursor to
the "KB Power On Password" field and press
<Enter>. Enter your password. You can enter up to
5 characters. Type in exactly the same password to
confirm, then press <Enter>.
Important:
The power button will not function once a
keyboard password has been set in the "KB
Power On Password" field. You must type the
correct password to power-on the system. If
you forgot the password, power-off the