Table of Contents
Advertisement
2.10.14 Chassis Open Connector
1 2 3 4
Chassis open
(J3)
The "chassis open" function, when enabled, will alert you that the
system chassis is open. To use this function, please follow the steps
below.
1. Connect the "chassis sensor" cable that is attached on your
system chassis to location J3 on the system board.
2. Install the "Winbond Hardware Doctor" utility contained in the
provided CD. By default, this function is disabled. When enabled,
a warning message will appear when the chassis is open. The
utility can also be configured so that a beeping alarm will sound
when the chassis is open. Refer to the "Winbond Hardware
Doctor" section in chapter 4 for information on installing the
utility.
Hardware Installation
Pin
Function
1
Ground
2
Chassis signal
3
N. C .
4
+5V
2
53
Advertisement
Table of Contents
