Toshiba e-STUDIO206L Service Manual page 1385

Sub
05/08 Mode Element
element
08 Setting Printer Process Conditions at the
mode occurrence of fuser
related error
08 Setting Printer Process Conditions at the
mode occurrence of fuser
related error
08 Setting Printer Process Conditions at the
mode occurrence of fuser
related error
08 Setting Printer General
mode
08 Setting Printer General
mode
08 Setting Printer Feeding Bypass paper size
mode system/Pa detection setting
per
transport
08 Setting Printer Feeding Bypass paper size
mode system/Pa detection counter
per
transport
08 Setting Printer General
mode
08 Setting Printer Counter
mode
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
4570
4570
4570
4581
4582
4621
4622
4675
4676
Sub- Default Acceptable
Details
code value value
1 Side thermistor 0 0-255
2 Edge thermistor 0 0-255
5 Error counter 0 0-255
SRAM Backup -
SRAM copy -
PPC/PRT 0 0~1
PPC/PRT 0 0~65535
Paper ejection setting 2
for wrong bypass
paper size
Ejection counter for 0 0~65535
wrong bypass paper
size
42
RAM Contents
M Output value of thermistor
M Output value of thermistor
M 1-3: Fusing error when warm-up-40-degrees C
detected
4-10: Fusing error when warm-up-100-degrees C
detected
11-25: Fusing error when ready from warm-up
50-55: Fusing error at ready
100-111: Fusing error at printing
150-153: Fusing error in the prewarming/JAM/cover
open/adjustment mode
- - The data in the SRAM is backed up in the EEPROM.
- - The data in the EEPROM is copied to the SRAM.
M Detects whether the size of paper fed by bypass
feeding is the same as the paper size set on the control
panel. If the sizes are not the same, the warning
message is displayed (Paper jam does not occur).
When the bypass paper size detection is broken, the
equipment can be used without the size detection by
disabling this setting. After repair, enable this setting.
0: Enabled 1: Disabled
M This is a counter for bypass paper size detection
setting. If the printing is executed with the paper size
that differs from the paper size set on the control panel,
the counter is counted up.
0-2 M 0 and 1: Disabled
2: Ejected
M Number of ejection times
Proc Service
edure UI
4
4
4
3
3
1
1
1
1