Cisco ONS 15600 SDH Troubleshooting Manual page 274

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3065 An error occurred while attempting to create this RMON
threshold:
{0}
EID-3066 The sample period must be between 10 and {0}.
EID-3067 The rising threshold must be between 1 and {0}.
EID-3068 The falling threshold must be between 1 and {0}.
EID-3069 The rising threshold must be greater than or equal to the falling
threshold.
EID-3070 Error in data for ports {0} Exactly one VLAN must be marked
untagged for each port. These changes will not be applied.
EID-3071 An error occurred while retrieving the learned address list.
EID-3072 An error occurred while clearing the learned address.
EID-3073 An error occurred while clearing the selected rows.
EID-3074 An error occurred while clearing the learned address list by {0}. Error encountered trying to clear the
EID-3075 At least one row in the parameter column must be selected.
EID-3076 CTC lost its connection with this node. The NE Setup Wizard
will exit.
EID-3077 No optical link was selected.
EID-3078 An optical link could not be created.
EID-3079 Defaults cannot be applied to the node. {0}
EID-3080 CTC cannot navigate to the target tab.
{0}
EID-3081 The port type cannot be changed.
EID-3082 The {0} extension byte cannot be changed.
EID-3084 An error occurred while retrieving laser parameters for {0}.
EID-3085 No OSC Terminations were selected
EID-3086 One or more Osc terminations could not be created.
EID-3087 The OSC termination could not be edited.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-18
Chapter 4 Error Messages
Description
You must wait some time before you try
again.
Refer to the error message text.
This is an invalid rising threshold entry. The
valid range is from 1 to the specified value.
This is an invalid falling threshold entry.
The valid range is from 1 to the specified
value.
Refer to the error message text.
CTC encountered data error for the
specified ports. Only one VLAN should be
marked untagged for each port.
Unable to retrieve the learned MAC address
from the NE.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
learned MAC address from either a VLAN
or a port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
CTC cannot apply the defaults to the
specified node.
CTC cannot go to the specified target tab.
Refer to the error message text.
You cannot modify the specified extension
byte.
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
Select an OSC termination and proceed.
Refer to the error message text.
Refer to the error message text.
July 2010