Table of Contents
Advertisement
3.3.4 ADMIN-LOCKOUT-CLR
3.3.4 ADMIN-LOCKOUT-CLR
The Admin Lockout Clear (ADMIN-LOCKOUT-CLR) condition occurs when the administrator unlocks
a user account or the lockout time expires.
This transient condition does not result in a standing condition.
3.3.5 ADMIN-LOGOUT
The Admin Logout of User (ADMIN-LOGOUT) condition occurs when the administrator logs off a user
session.
This transient condition does not result in a standing condition.
3.3.6 ADMIN-SUSPEND
The Suspend User (ADMIN-SUSPEND) condition occurs when the password for a user account expires.
This transient condition does not result in a standing condition.
3.3.7 ADMIN-SUSPEND-CLR
The Suspend User Clear (ADMIN-SUSPEND-CLR) condition occurs when the user or administrator
changes the password.
This transient condition does not result in a standing condition.
3.3.8 AUTH-FAIL
The Remote Authentication Fail - See Audit Log (AUTH-FAIL) condition indicates that an attempt to
validate a login remotely has failed.
This transient condition does not result in a standing condition.
3.3.9 DBBACKUP-FAIL
The Database Backup Failed (DBBACKUP-FAIL) condition occurs when the system fails to back up the
database when the backup command is initiated.
This condition can occur when the server is not able to handle the backup operation due to network or
server issues. Repeat the same operation again and check to see if it is successful. If the backup fails, it
could be due to a network issue or software program failure. Contact the Cisco Technical Assistance
Center (Cisco TAC) for assistance; see the
Request" section on page xxxii
3.3.10 DBRESTORE-FAIL
The Database Restore Failed (DBRESTORE-FAIL) condition occurs when the system fails to restore the
backed up database when the restore command is initiated.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
3-4
"Obtaining Documentation and Submitting a Service
as needed.
Chapter 3 Transient Conditions
July 2010
Advertisement
Table of Contents
Troubleshooting
