Improprmvl (Eqpt, Pim, Ppm) - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.100 IMPROPRMVL (EQPT, PIM, PPM)

Choose Delete from the shortcut menu.
Step 2
Note
Step 3 If any ports on the card are in service, place them out of service (Locked,maintenance) by completing
the following steps:
Before placing a port out of service (Locked,maintenance or Locked,disabled), ensure that no live traffic
Caution
is present.
In node view, double-click the reporting card to display the card view.
a.
Click the Provisioning > Line tabs.
b.
Click the Admin State column of any in-service (Unlocked) ports.
c.
Choose Locked,maintenance to take the ports out of service.
d.
If a circuit has been mapped to the card, delete it using the procedure in the "Manage Circuits" chapter
Step 4
in the Cisco ONS 15600 SDH Procedure Guide.
Before deleting the circuit, ensure that the circuit does not carry live traffic.
Caution
Step 5 If the card is paired in a protection scheme, delete the protection group by completing the following
steps:
a. Click View > Go to Previous View to return to node view.
b. If you are already in node view, click the Provisioning > Protection tabs.
Click the protection group of the reporting card.
c.
Click Delete.
d.
If the card is provisioned for DCC, delete the DCC provisioning by completing the following steps:
Step 6
Click the node view Provisioning > Comm Channels > RS-DCC tabs.
a.
Click the slots and ports listed in DCC terminations.
b.
Click Delete and click Yes in the dialog box that appears.
c.
If the card is used as a timing reference, change the timing reference by completing the following steps:
Step 7
Click the Provisioning > Timing > General tabs.
a.
Under NE Reference, click the drop-down arrow for Ref-1.
b.
c. Change Ref-1 from the listed STM-N card to Internal Clock.
d. Click Apply.
Step 8 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)
problem.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-72
CTC does not allow you to delete the reporting card if the card is in service, does have circuits
mapped to it, is paired in a working protection scheme, has DCC enabled, or is used as a timing
reference. However if none of these services is provisioned, you can delete an Unlocked card.
Chapter 2 Alarm Troubleshooting
July 2010