Cisco ONS 15600 SDH Troubleshooting Manual page 263

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2065 The profile cannot be imported.
The profile "{0}" exists in the editor and the maximum number
of copies (ten) exists in the editor.
The import will be aborted. The profile has already been loaded
eleven times.
EID-2066 The profile could not be stored.
An error occurred while writing to {0}.
EID-2067 An error occurred while writing to the file.
{0}
EID-2068 The alarm profile could not be loaded from the node.
EID-2069 The file could not be found or an I/O exception occurred.
{0}
EID-2070 The profile could not be deleted.
{0}
EID-2071 Only one column may be highlighted.
EID-2072 Only one profile may be highlighted.
EID-2073 This column is permanent and cannot be removed.
EID-2074 Select one or more profiles.
EID-2075 This column is permanent and cannot be reset.
EID-2077 This column is permanent and cannot be renamed.
EID-2078 At least two columns must be highlighted.
EID-2079 The alarm types cannot be loaded into table.
There are no reachable nodes from which the list of alarm types
can be loaded.
Please wait until such a node is reachable and try again.
EID-2080 The node {0} has no profiles.
EID-2081 An error occurred while removing profile {0} from the node
{1}.
EID-2082 The profile {0} does not exist on the node {1}.
EID-2083 An error occurred while adding profile {0} to the node {1}.
EID-2085 The profile selection is invalid.
No profiles were selected.
July 2010
Description
Cannot import the profile because the
profile has reached the maximum number of
copies in the editor.
CTC encountered an error while trying to
store the profile.
CTC encountered an error while writing the
specified file.
CTC encountered an error trying to load the
alarm profile from the node.
Either the specified file was not found, or
there was an input/output exception.
There was a failure in deleting the specified
profile.
You cannot select more than one column
during clone action.
You cannot select more than one profile.
You cannot delete a permanent column.
You have not selected any profile or
column. Reset operation is done by
right-clicking the selected column.
A permanent column is non resettable.
You cannot rename a permanent column.
You connot compare two profiles unless
you select two columns.
Refer to the error message text.
The specified node does not have any
profiles.
There was an error while removing the
specified profile from the specified node.
CTC cannot find the specified profile from
the specified node.
There was an error adding the specified
profile to the specified node.
You tried to select an invalid profile. Select
another profile.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-7