Cisco ONS 15600 SDH Troubleshooting Manual page 286

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3358 An optical link model does not exist for the specified interface. Create an optical link model for the
EID-3359 Optical parameters could not be set for the node.
EID-3360 ANS cannot be performed.
Please check {0} parameter value.
EID-3361 The ring termination is in use.
An error occurred while deleting the ring termination.
EID-3362 An error occurred while deleting the ring termination.
EID-3363 No ring terminations were selected.
EID-3364 An error occurred while creating the ring ID.
EID-3365 The OSC termination is in use.
EID-3366 The OSC termination could not be deleted.
EID-3370 No optical link was selected.
EID-3371 An error occurred while calculating the automatic optical link
list.
EID-3372 CTC attempted to access an OCHNC connection that has been
destroyed.
EID-3375 The expected span loss must be set.
EID-3376 The measured span loss could not be retrieved.
EID-3377 The wrong interface was used.
EID-3378 This is a duplicate origination patchcord identifier.
EID-3379 This is a duplicate termination patchcord identifier.
EID-3380 The host cannot be found.
EID-3381 The maximum frame size must be between {0} and {1} and
may be increased in increments of {2}.
EID-3382 The number of credits must be between {0} and {1}.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-30
Chapter 4 Error Messages
Description
interface, and proceed.
Refer to the error message text.
Refer to the error message text.
You cannot delete a ring in use.
There was an error while deleting ring
termination.
You must select a ring termination.
There was an error while creating the ring
ID.
Select another optical service channel
(OSC) which is not in use.
There was an error deleting the OSC
termination.
You must select an optical link.
Refer to the error message text.
CTC destroyed an external attempt to
access an optical channel network
connection.
Refer to the error message text.
Refer to the error message text.
The interface used for the card is wrong.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the origination node.
The provisionable patchcord identifier to
the patchcord you are attempting to
provision is already in use by another
patchcord on the remote node.
Refer to the error message text.
The frame size must be in the specified
range. This can incremented by the
specified value.
The number of credits must be between the
specified values.
July 2010