Cisco ONS 15600 SDH Troubleshooting Manual page 285

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3327 An error occurred while retrieving thresholds.
EID-3328 An error occurred while applying changes to row {0}.
The value is out of range.
EID-3330 Unable to switch to the byte because an overhead channel is
present on this byte of the port.
EID-3331 An error occurred while applying changes to the row.
EID-3334 Timing parameters on the protect port cannot be changed.
EID-3335 The port type cannot be changed because the SDH validation
check failed. Check if this port is part of a circuit, protection
group, SONET DCC, orderwire, or UNI-C interface.
EID-3336 An error occurred while reading a control mode value.
EID-3337 An error occurred while setting a set point gain value.
EID-3338 An error occurred while reading a set-point gain value.
EID-3339 An error occurred while setting a tilt calibration value.
EID-3340 An error occurred while setting expected wavelength.
EID-3341 An error occurred while reading expected wavelength.
EID-3342 An error occurred while reading actual wavelength.
EID-3343 An error occurred while reading actual band.
EID-3344 An error occurred while reading expected band.
EID-3345 An error occurred while setting expected band.
EID-3346 An error occurred while retrieving defaults from the node: {0}. There was an error retrieving defaults from
EID-3347 The file {0} cannot be loaded.
EID-3348 Properties cannot be loaded from the node.
EID-3349 NE update properties cannot be saved to a file.
EID-3350 NE update properties cannot be loaded from the node.
EID-3351 The file {0} does not exist.
EID-3352 An error occurred while setting a value at {0}.
EID-3353 No such interface is available.
EID-3354 The specified endpoint is in use.
EID-3355 The specified endpoint is incompatible.
EID-3357 The connections could not be calculated.
July 2010
Description
There was an error retrieving the thresholds.
This message is displayed only for the
OSCM/OSC-CSM line thresholds.
There was an error applying the changes to
the specified row. The value is out of range.
Refer to the error message text.
Refer to the error message text.
You cannot change timing parameters on
protect port.
Refer to the error message text.
The Control Mode must be retrieved.
The Gain Set Point must be set.
The Gain Set Point must be retrieved.
The tilt calibration must be set.
The expected wavelength must be set.
The expected wavelength must be retrieved.
The actual wavelength must be retrieved.
The actual band must be retrieved.
The expected band must be retrieved.
The expected band must be set.
the specified node.
CTC cannot load the specified file.
Refer to the error message text.
Check your file system for space constraint
or any other problem.
Refer to the error message text.
The specified file does not exist.
There was an error while setting the value at
the specified location.
The interface specified is not present in
CTC.
Select another endpoint that is not in use.
Refer to the error message text.
Refer to the error message text.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-29