Cisco ONS 15600 SDH Troubleshooting Manual page 272

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3007 An error occurred while provisioning the {0}.
EID-3008 This is not a valid card.
EID-3009 No {0} was selected.
EID-3010 A bidirectional optical link could not be created.
EID-3016 The subnet address is invalid.
EID-3017 The subnet address already exists.
EID-3019 The internal subnet address is incomplete.
EID-3020 The subnet address cannot be the same for both TSC cards.
The requested action is not allowed.
EID-3021 An error occurred while retrieving the diagnostics:
{0}
EID-3022 The requested action is not allowed.
EID-3023 The low order cross-connect mode could not be retrieved.
EID-3024 The {0} cross-connect mode could not be switched.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
EID-3025 An error occurred while retrieving thresholds.
EID-3026 The send DoNotUse attribute cannot be modified.
EID-3027 The SyncMsg attribute cannot be modified.
EID-3028 The port type cannot be changed.
EID-3029 Unable to switch to the byte because an overhead change is
present on this byte of the port.
EID-3031 An error occurred while hard-resetting the card.
EID-3032 An error occurred while resetting the card.
EID-3033 The lamp test is not supported on this shelf.
EID-3035 The cross-connect diagnostics cannot be performed
EID-3036 The cross-connect diagnostics test is not supported on this
shelf.
EID-3039 An error occurred while changing the card type.
EID-3040 The card type is invalid.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-16
Chapter 4 Error Messages
Description
There was a provisioning error for the
specified item.
You cannot perform DWDM automatic
node setup (ANS) from the card view.
Please navigate to the node view and try
again.
Select the specified item, for example,
VLAN, port, slot, etc.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Enter the complete internal subnet address.
A node's internal subnet must be different
from one another as each TSC is on separate
ethernet buses, isolated by broadcast
domains.
Refer to the error message text.
The requested action is not allowed.
Refer to the error message text.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
There was an error retrieving the thresholds.
You cannot modify the Send DoNotUse
field.
You cannot modify the SyncMsg field.
You cannot change the port type.
Refer to the error message text.
There was an error while resetting card
hardware.
There was an error while resetting the card.
Refer to the error message text.
Refer to the error message text.
The cross-connect diagnostics test is not
supported on this shelf.
There was an error while changing the card.
The selected card type is invalid.
July 2010