Power Supply - Radio Thermostat CT200 User Manual

Z-Wave and Power Supply
The Thermostat's node type is fixed when it is included to
the Z-Wave network; if the C-Wire is not connected and is
only battery-powered when including to the network, the
Thermostat will remain a frequent listening routing slave
(FLiRS) node until it is removed from the network
When your thermostat is running on battery power, the Z-Wave
radio will turn off to help conserve battery life. The Thermostat
Z-Wave radio module supports Z-Wave beaming, which allows other
devices in the network to wake up the Z-Wave module and accept
commands and then go back to sleep
When your thermostat is running on C-Wire power, the Z-Wave radio
will stay on and actively help route messages within the Z-Wave
network. The thermostat's node type is fixed when it is included to
the Z-Wave network; if the C-Wire is present and powered when
including to the network, the thermostat will remain an always-
listening node until it is removed from the network
16
Vivint Element CT200 Installation Guide
Setup