Power Supply - Radio Thermostat CT200 User Manual

Power Supply

While the thermostat can run without batteries on C-wire power,
you should install batteries as well to provide power to the unit
during outages See the Thermostat Battery Cautions
1 Install four (4) AA alkaline batteries following the marked polarity
in the battery compartments. Insert the battery negative end first
against the spring, then push the positive end in
2 With all the wires connected and the unit attached to the wall, it
is time to turn the AC power back on Reconnect the power at the
breaker you used to switch it off. The Thermostat will power-up in
the OFF mode
3 Your Thermostat is not yet configured to operate your HVAC
system You must now connect your thermostat to a Z-Wave
Network and configure the HVAC and Heat Source settings.
Battery Installation
12
Vivint Element CT200 Installation Guide
Wiring