Include Device To A Z-Wave Network - Radio Thermostat CT200 User Manual

You must add the Thermostat to a Z-Wave network This
unit cannot operate without a network connection
Include the Thermostat to a Z-Wave
The Vivint Element Thermostat is a Z-Wave
It has an onboard radio that can be added to an existing Z-Wave
network This device can be used on a network with products from
different vendors.
1 Set your primary controller
to INCLUDE mode to add the
thermostat as a node on your
network (see your specific
controller's User Manual for
detailed instructions)
2 The Thermostat main screen shows
a welcome message Press the
SIDE button to continue
3 Press the SIDE button to initiate the
inclusion process This initiates the
network connection process
• If inclusion fails, the screen says
"Failed". Press the SIDE button to
try adding again
4 When the Thermostat has been
successfully included to a Z-Wave
network, the screen displays a
confirmation check mark. Press the
SIDE button to continue
You can now configure the
thermostat to work with your HVAC
system
5 Your primary controller indicates that the thermostat was
successfully added to its network (see your specific controller's
User Manual for details)
Exclude from a Z-Wave Network
The Vivint Element can be excluded from the Z-Wave network
process similar to the inclusion process Set your primary controller
to EXCLUDE
Vivint Element CT200 Installation Guide
compliant thermostat
®
Setup
Network
®
2
CONNECT
WITH
SKY
NEXT
®
3
4
15