MAINTENANCE WORK ON CHASSIS AND ENGINE
Fork offset
8.23
A
0 0 A
–
Tighten screw
Specification
Screw, top steering stem
–
Fully tighten screw
Specification
Screw, top triple clamp
600100-12
–
Position the steering damper
Specification
Remaining screws, chassis
–
Open the cable binders and position the handlebar.
–
Position the holding plate with handlebar clamps. Mount and tighten screws
Specification
Screw, handlebar clamp
600099-11
–
Mount the trim. (
The fork offset
the center of the fork leg to the center of the steering head bearing.
The fork offset can optionally be adjusted.
400356-10
When the mark 1 is visible in the bore
dling in bends.
Fork offset
Mark 1 visible
If the mark 1 is not visible in the bore
stretches.
Fork offset
No mark
600111-10
.
.
. Mount and tighten screws
P. 54)
has an impact on the handling of the vehicle. It is calculated from
(as delivered), you will achieve better han-
20 mm (0.79 in)
, you will achieve better riding stability on fast
22 mm (0.87 in)
M8
20 Nm
(14.75 lbf ft)
M8
17 Nm
(12.54 lbf ft)
.
M6
10 Nm
(7.38 lbf ft)
M8
16 Nm
(11.8 lbf ft)
37
.