Adjusting The Headlamp; Removing The Battery - KTM 690 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adjusting the headlamp

8.70
0 0 A A

Removing the battery

x
8.71
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
–
Remove the trim. (
–
On a light-colored wall in front of which there is a horizontal surface, make a mark
at the height of the center of the low beam headlamp.
–
Make another mark at a distance
Specification
0 0 B B
Distance

–
Position yourself with the motorcycle at a distance
switch the low beam on.
Specification
400355-10
Distance

–
Loosen screws
ready-to-operate motorcycle with a rider until the light-dark boundary lies exactly
on the lower mark.
–
Tighten screws
–
Mount the trim. (
600102-10
–
Switch off all power-consuming components and switch off the engine.
–
Remove the seat (
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover and disconnect the positive (plus) cable
tery.
–
Remove screws
–
Lift the battery
600068-11
P. 54)
below the first mark.

5 cm (1.97 in)
5 m (16.4 ft)
and . Swivel the headlamp bracket
 
and .
 
P. 54)
P. 55)
of the battery

. Remove the retaining bracket

up and remove it.

in front of the wall and

and headlamp of the

.

of the bat-

.

60