Checking Rear Brake Fluid Level; Topping Up Brake Fluid Of Front Brake - KTM 690 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Checking rear brake fluid level

8.46
Warning
Danger of accidents Brake system failure.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
Warning
Danger of accidents Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.

Topping up brake fluid of front brake

8.47
Warning
Danger of accidents Brake system failure.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
KTM recommends DOT 5.1 brake fluid from Motorex
greater safety for high demands.
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Stand the vehicle upright.
–
Check the brake fluid level in the brake fluid reservoir
» When the fluid level reaches the MIN mark
–
Top up the brake fluid of the rear brake. (
600060-10
x
® . This has a higher wet boiling point than DOT 4 brake fluid and provides
–
Stand the vehicle upright.
–
Turn the brake fluid cap
brane .

–
Top up the brake fluid to level
Brake fluid DOT 5.1 (
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Insert the membrane
cap .

600061-10
–
Clean up overflowed or spilt brake fluid immediately with water.
:

in the direction of the arrow and remove it with mem-

.

P. 96)
into the brake fluid reservoir and mount the brake fluid

47
.

P. 47)