MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking engine oil level
8.83
Info
The engine oil level can be checked on a cold or hot engine.
Changing engine oil and oil filter, cleaning oil screen
8.84
–
Remove the motor guard. (
–
Drain the engine oil. (
–
Remove the oil filter. (
–
Clean the oil screen. (
–
Mount the oil filter. (
P. 70)
–
Fill up with engine oil. (
–
Mount the motor guard. (
Draining the engine oil
x
8.85
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
–
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Drain the engine oil only when the engine is warm.
–
Stand the motorcycle upright on a horizontal surface.
Conditions
The engine is at operating temperature.
–
Check the engine oil level.
The engine oil reaches the top of the viewer
»
400304-10
P. 58)
P. 67)
P. 68)
P. 69)
P. 70)
P. 59)
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Place a suitable container under the engine.
–
Remove the oil drain plug
–
Completely drain the engine oil.
–
Thoroughly clean the oil drain plug with a magnet.
–
Clean the sealing area on the engine.
–
Check parts for damage and wear. Replace damaged or worn parts.
–
Fit oil drain plug
Specification
600075-10
Oil drain plug with magnet
When the engine oil does not reach the top of the viewer:
–
Top up the engine oil. (
x
and the seal ring.
with seal ring and tighten it.
.
P. 71)
M12x1.5
20 Nm
(14.75 lbf ft)
67