Samsung MIM–B18BN User & Installation Manual page 81

Device Configuration
Checking and changing the Object ID
List of equipment connected to LonWorks can be checked when
the tracking is completed.
1 Device Type, Address, Name and Object ID will appear.
2 Object IDs are assigned in order from 1 to 128 when initial
tracking is executed.
3 If you want to change the Object ID, click [Edit] and
change the Object ID of the applicable device.
The Object ID can not be used for more than one piece
of device.
Object ID can be entered between 1 ~ 128.
Device without an Object ID can not transfer its
information to LonWorks.
Object ID does not appear if there are more than 128
indoor units.
Checking device information
1 Click one of the Addresses from 'Address' colum.
Detail information of the selected device will be displayed
in device information.
2 You can check the value of each Input item.
Note The value of the Input item represents the current
status of the device.
Therefore, value may be different from the final status
controlled by LonWorks MMI.
Some values cannot be altered depending on their
connection to a type of device
(Indoor unit, ERV, AHU kit, Fresh ducts).
3 Check the current value of the Output.
The current value indicates the current status of
indoor unit(ERV) and the value can be different due to
synchronization delay with LonWorks MMI and data
conversion.
Refer to LonWorks Message Definition for device
information display for each device.
81
E-