Samsung MIM–B18BN User & Installation Manual page 79

6 If you login successfully, 'Control and Monitoring' screen of DMS2.5 will appear.
Click [System Setting]➔[LonWorks configuration] menu to switch to LonWorks
Gateway.
If you use accounts with authorization level lower than management group or
accounts with general authorization level, LonWorks configuration will not be
displayed on the menu.
If the LonWorks configuration menu does not appear, consult the manager.
If you access LonWorks Gateway, 'Device Configuration' screen will appear initially.
7
If you click [DMS2.5 Connect] button, screen will be switched to initial screen of
the DMS2.5.
Reading EHP Watt-hour Meter
Setting and checking watt-hour meter
1 Click [Setting and Checking Watt-hour meter].
You can change settings on watt-hour meter only when SIM/PIM interface
module is connected.
Click [Edit] from the 'Setting and checking Watt-hour meter' screen.
2
CT proportion is set to '1' as factory default value.
3 Set the [Name] and [CT proportion] for the watt-hour meter.
You can use maximum 16 letters for name and only available special characters
are ".", ",", " _ ", "-", and "space".
Value for CT proportion should be integer between range of 1 ~ 5000.
4 Click [Save].
Changed settings will be saved to the LonWorks Gateway.
If you do not click [Save] changed setting will not be saved.
5 Watt-hour meter value will display the actual value of electricity on the
corresponding watt-hour meter. Value will be updated automatically.
When using CT watt-hour meter, be careful that there can be difference with
actual power consumption as much as CT ratio error.
79
E-