Lanpower Priority-Disconnect - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Power over Ethernet (PoE) Commands

lanpower priority-disconnect

Enables or disables the priority disconnect function on all ports in a specified slot. Priority disconnect is

used by the system software in determining whether an incoming PD will be granted or denied power

when there are too few watts remaining in the PoE power budget for an additional device. For detailed

information on this function, refer to the "Managing Power over Ethernet (PoE)" chapter in the

OmniSwitch 6250 Series Hardware Users Guide.

lanpower slot priority-disconnect {enable | disable}

Syntax Definitions

enable | disable

Platforms Supported

OmniSwitch 6250-Enterprise Models

Usage Guidelines

-> lanpower 2 priority-disconnect disable

Release History

Release 6.6.1; command was introduced.

OmniSwitch 6250 CLI Reference Guide

The particular slot on which the priority disconnect function is being

enabled or disabled.

Enables priority disconnect on a specified port. When this function is

enabled and a power budget deficit occurs in which there is inadequate

power for an incoming device, the system software uses priority discon-

nect rules to determine whether an incoming device will be granted or

denied power. For information on priority disconnect rules, refer to the

"Managing Power over Ethernet (PoE)" chapter in the OmniSwitch

6250 Series.

Disables priority disconnect on a specified port. When priority discon-

nect is disabled and there is inadequate power in the budget for an addi-

tional device, power will be denied to any incoming PD, regardless of

its priority status.

November 2009