Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 182

!
Recalls commands listed in the history buffer and displays them at the CLI prompt.
!{! | n}
Syntax Definitions
!
n
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
You can use the show history
syntax to issue a single command from the list.
•
When you use !n or !! to recall a command in the history buffer list, you must press the Enter key to
execute the command.
Examples
-> show history
1* show cmm
2 show fan
3 show sensor
4 show temp
5 show time
6 show arp
7 clear arp
Release History
Release 6.6.1; command was introduced.
page 6-22
Recalls the last command listed in the history buffer and displays that
command at the CLI prompt.
Identifies a single command in the history buffer by number and
displays that command at the CLI prompt.
command to list all commands in the history buffer, then use the !n
OmniSwitch 6250 CLI Reference Guide
Session Management Commands
November 2009