Lacp Agg Partner Admin Port Priority - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

lacp agg partner admin port priority

Configures the priority for a partner port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin port priority
partner_admin_port_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin port priority
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
partner_admin_port_priority
Defaults
parameter
partner_admin_port_priority
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a partner_admin_port_priority value from a slot and port
associated with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 20, "Ethernet Port Commands,"
Examples
-> lacp agg 2/1 partner admin port priority 100
-> lacp agg 2/1 no partner admin port priority
Release History
Release 6.6.1; command was introduced.
page 12-42
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
The priority of the partner port. Possible values are 0–255.
default
0
for information on CLI commands to configure Ethernet ports.
OmniSwitch 6250 CLI Reference Guide
Link Aggregation Commands
November 2009