Lanpower Maxpower - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Power over Ethernet (PoE) Commands

lanpower maxpower

Specifies the maximum amount of inline power, in watts, allocated to all PoE ports in a specified slot.
lanpower slot maxpower watts
Syntax Definitions
slot
watts
Defaults
parameter
watts
Platforms Supported
OmniSwitch 6250-Enterprise Models
Usage Guidelines
•
Before changing the maximum slot-wide power allowance, you must disable PoE for the slot via the
lanpower stop command. Once the new value is assigned, re-enable PoE for the slot via the
start command.
•
To specify the maximum amount of inline power allocated to a single port, refer to the
power command on page
•
Note that the power value for the
command, lanpower
Examples
-> lanpower 3 maxpower 200
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The slot containing PoE ports on which the maximum amount of inline
power allowed is being allocated.
The maximum amount of inline power, in watts, allocated to all PoE
ports in the corresponding slot (37–225).
default
225
4-5.
lanpower maxpower
power, is specified in milliwatts (mW).
November 2009
command is specified in watts (W); the related
lanpower
lanpower
page 4-7