Setting The Thread Cutter Parameter (Thread Trim); Setting The Thread Clamp Parameter (Thread Clamp); Setting The Initial Alignment Stitch Parameter (Pointpos.°) - Duerkopp Adler 669 Premium Operating Instruction

56
5.4.3 Setting the Thread cutter parameter
(Thread Trim)
Set whether the thread cutter is activated or deactivated at the
end of the seam.
Menu item
(Thread Trim)
Thread cutter
5.4.4 Setting the Thread clamp parameter
(Thread Clamp)
If a thread clamp is present, this function can be activated or
deactivated here. The thread clamp is closed for the 1
the seam to ensure that the needle thread lies on the underside
of the sewing material.
Menu item
(Thread Clamp)
Thread clamp
5.4.5 Setting the Initial alignment stitch parameter
(PointPos.°)
The distance of the needle from the material can be adjusted
to allow precise positioning of the sewing material when starting
sewing. The value entered here corresponds to the degree number
on the handwheel.
Menu item
(PointPos.°)
Initial alignment stitch
function
Operating Instructions 669 PREMIUM - 00.0 - 11/2016
Setting option
ON = on
OFF = off
Setting option
ON = on
OFF = off
Setting option
000 – 359 [°]
Programming
st
stitch of