Setting The Thread Cutter - Duerkopp Adler 2211-5 Working Instructions

Short Seam Automat 2211-5 Working Instructions
C.5
C.5.5 Machine set-up

Setting the thread cutter:

The three-digit value input (GP Par. 35) determines when
the thread cutter is activated.
The setting of the thread cutter must be checked during
machine operation and corrected as required.
1. Rotate sewing head handwheel in direction of machine
rotation until needle reaches highest point (pinning po-
sition C).
Lock handwheel at position C by depressing pinning
pin of hole to left of handwheel.
2. Fig. 26: Install drive belt
key is flush with motor housing mark
3. Unlock handwheel.
4. Call menu Global Parameters:
• Press key
• Press GP key
Insert the following values in Global Parameters:
35: Thread lever in position up
36: Switch-on pos. for thread cutting
Store value and exit setting level:
• Press key
5. Start the thread cutting function:
• Press key
• Press diagnostics key
• Press sewing motor key
Maintenance
so that the shaft feather
.
200 INC
110 INC
Fig. 26
• Press thread cutter key
Start or stop machine run:
• Press key
6. Check position C to see if shaft feather key
with motor housing mark
If required, change values and test thread cutting func-
tion.
7. Start thread cutting and recheck positions.
- C 63 -
Beisler Automated Sewing Equipment
.
Fig. 26
is flush