Duerkopp Adler 669 Premium Operating Instruction page 53

Programming
Operating Instructions 669 PREMIUM - 00.0 - 11/2016
Symbol Meaning
Sewing foot pressure
Value range: 01 - 20
• Use ◄/► to select the Sewing foot pressure parameter
• Use ▲/▼ to change the sewing foot pressure
Sewing foot stroke
Value range: 00.0 – 09.0 [mm] (0.5 mm increments)
• Use ◄/► to select the Stroke height parameter
• Use ▲/▼ to change the stroke height
Other parameters
• Use the OK button to go to the list
• Use ▲/▼ to select the parameter
• Use the OK button to go to the parameter settings
More detailed description of parameters:
• Speed (Max. Speed) ( p. 55)
• Thread cutter (Thread Trim) ( p. 56)
• Thread clamp (Thread Clamp) ( p. 56)
• Initial alignment stitch (PointPos.°) ( p. 56)
• Start bartack (Start Tack) ( p. 57)
• End bartack (End Tack) ( p. 60)
• Sewing foot lift (Foot) ( p. 62)
• Bobbin monitor (Bobbin) ( p. 62)
• Information (Info) ( p. 65)
• Edge stop (Edge Guide) ( p. 66)
• Correcting effects of high speed (Speed Corr.) ( p. 66)
• Material thickness detection (Fabric Thickness)
( p. 71)
S.p.m. or seam length in [mm]
The active option, either s.p.m. or mm, can be set at the
Technician level. The s.p.m. option is set at the factory.
After the thread has been cut off, the display is retained.
Measurement/counting restarts when sewing starts again.
• Cancel the function
• Exit the menu (changes remain saved) to return to the
starting level
• Confirm the settings
• Activate the input
51