Zenith z-server lt User Manual page 21

3-4
Diskette A and Diskette B — Both Diskette A and Diskette B
settings allow you to select which type of drive you have installed.
Onboard IDE — This setting must always be disabled.
Hard Drive 1 and Hard Drive 2 — The setting must always
be set to "Not Installed".
Onboard SCSI — This setting must be enabled if you are using
the onboard SCSI.
Video Type — Select the VGA/EGA option to use the high
performance onboard video system. Change the setting if you
have installed an add-in video controller board. Install the
appropriate video drivers for your system environment and
applications.
640  480 Refresh Rate — Select the refresh rate that your
video display vertical sync supports when in 640  480 mode.
800  600 Mode Refresh Rate — Select the refresh rate that
your video display vertical sync supports when in 800  600 mode.
1024  768 Mode Refresh Rate — Select the refresh rate that
your video display vertical sync supports when in 1024  768
mode.
Video Font — This setting controls character resolution.
Onboard Video Controller — Select the onboard video
controller based on whether the video display connected to the
onboard video controller is the primary or the secondary video
display. All BIOS video writes are directed to the primary video
display.
Configuring Your System