Snap-Jet Gas Ignition System Maintenance - Weber Summit Series Owner's Manual

SNAP-JET
SNAP-JET GAS IGNITION
™
SYSTEM OPERATION
The burner control knob has a built-in igniter. The
igniter supplies a spark to the igniter electrode
assembly. Whether you are performing routine
maintenance or a troubleshooting check on the
Snap-Jet gas ignition system, read the following
™
to keep the system working properly.
m WARNING: The burner control knob
should be in the OFF position.
If the grill fails to ignite when you push the burner
control knob in and turn it slowly, you will need
to pinpoint where the problem is occurring: with
the gas flow or with the ignition system. Begin
by attempting to match light your burner. Refer
to "BURNER IGNITION – Lighting with a Match."
If match lighting is successful, the problem lies in
the Snap-Jet gas ignition system.
™
MAINTAINING THE IGNITION
COMPONENTS
1. Confirm that grill is off and cool.
2. Check that the black wire is connected to the
red terminal on the valve (A).
3. Check that the white wire is connected to the
ground terminal at screw (B).
GAS IGNITION SYSTEM MAINTENANCE
™
B
A
31